DIY is do it yourself, to assemble the needed parts so that meet people’s different demands.DIY laptop is also according to their own needs to assemble parts, accessories can be assembled just like the CPU, hard disk, and memory. DIY desktop computer is very welcomed and has been recognized by consumers. Probably DIY laptop will become popular in the near future.

Heat pipe heat sink, processor and CPU fan.

First anti-owned laptop, find a good fit screwdriver.

Using the screwdriver to remove the tailgate of CPU, it is very simple.

Then we can see the true colors of the inside.

CPU slot
The middle is the CPU socket, CPU on the concave side and down the left side of the part is to install heat pipe heat sink and fan location. The CPU-right and lower side respectively Mini PCI wireless card and memory space. Then start to install CPU, put the right of CPU socket to push into the vertical position.

Remove the CPU, make CPU pins on the socket on the gaps and gaps in alignment. After installed CPU, we need to check it. Then to install heat pipe heat sink and fan, the heat pipe is providing cooling for the CPU and graphics card.

The next step is to install a heat pipe heat sink and fan.

Picture shows the ATI Mobility Radeon X700 graphics processing chip.

The heat pipe heat sink alignment to the CPU, they would not rush to fix screws.

We need to make sure the core cooling of heat pipe heat sink first.

Fix the four screws of the CPU cooling part.

Then fix the screws of core cooling.

This notebook’s cooling system is fixed.

The next step is to install the fan, we should connect fan power supply and power interface of motherboard first.

Then put the fan into the groove, tighten three screws, fans also can be fixed.

Then we completed the CPU, fan and heat pipe heat sink installation.

Real memory and wireless network card installed:

Memory
Now is the time to install the memory, laptop provides two memory slots.

First, we will be the memory of about 40 degrees angles into the memory slot.

Push the button down carefully and the memory into the appropriate location.

Using the same method to install the second memory.

The next step is to install a wireless network card with a Mini PCI interface.

Wireless Network Card With PCI interface
Installation method is similar with installation method of the memory, make the slant and fix the card slot then gently press down to inside.

Install the antenna of Mini PCI wireless network card.

Wiring.

Memory and wireless network card are now also installed successfully.

The third step: install hard drives and CD-ROM

The majority of notebook hard drives are now very easy to install, some laptop provides a hard disk protection box to install, let’s start the hard disk installation .

We put hard drive and the protection box together.

Set the right location of hard disk data interface with the laptop motherboard hard drive interface, then pull the hard disk into the drive position.

Fix four screws around the drive and the hard drive also installed.

CD-ROM installation is also very simple, just gently to the optical storage inside a plug on it.

Power supply installation, first loosen the two sides of battery storage locking, and then prepare the battery, gently pushed into the alignment interface.
Then close the both side of battery lock.

Now load up the tailgate, complete the process of DIY whole hardware.

The above is the whole process of DIY hardware, when it is all done, we can install the operating system and associated drivers.